[PLUTO-help] =?utf-8?q?incompatibilit=E0_pc-router?= (assurdo)
miKe
m.m.asciutti a email.it
Lun 4 Feb 2008 20:22:38 CET
Alle 12:27 di lunedì 4 febbraio 2008, in merito a R: [PLUTO-help]
incompatibilità pc-router (assurdo), Tiziano Stocco ha scritto:
> Ciao, molto interessante...e tragico...
direi più che altro "inconsueto"
;)
>
> Escluderei un problema hardware dei pc e dei server
> Proverei a collegare il router direttamente a un pc e non a tutta la
> rete per poter fare delle prove senza eventuali problemi di conflitti (a
> mio avviso remotissimi).
ora il server è collegato direttamente al router, spegnendo lo switch che
collega gli altri pc purtroppo non cambia nulla..
> Comunque tutto mi fa pensare a un firewall mal configurato o a un port
> fowarding altrettanto mal configurato quindi proporrei un reset hardware
> (sicuramente l'hai già fatto...) e
si...
queste sono le conf principali, come si vede più aperto di così è
impossibile..
--> firewall status
Firewall disabled.
Firewall security level: none.
Firewall packetfilter mode : bypass.
Firewall session logging enabled.
Firewall blocking logging enabled.
Firewall intrusion logging enabled.
webserver:Apply Changes
--> firewall list policies
Firewall Policies:
ID | Name | Type 1 | Type 2 | Validator Allow Only
-------------------------------------------------------------------
-------------------------------------------------------------------
--> firewall show IDS
Firewall IDS:
IDS Enabled: false
Use Blacklist: false
Use Victim Protection: false
Dos Attack Block Duration: 1800
Scan Attack Block Duration: 86400
Victim Protection Block Duration: 600
Max TCP Open Handshaking Count: 200
Max PING Count: 15
Max ICMP Count: 100
--> ip show debuginfo
Found IP stack.
Interfaces:
-----------
IfIndex: 1 Name: ppp-0 Addr: 81.174.46.*** Mask:
255.255.255.255
All addresses:
81.174.46.*** 255.255.255.255
224.0.0.9 0.0.0.0
IGMP membership:
DHCP: disabled MSS Clamp: disabled
Rx Filter: present Tx Filter: present
IfType: PTP
Virtual: No Device: //ppp/DEVICE=1
IfIndex: 2 Name: lanip1 Addr: 10.22.115.22 Mask:
255.255.255.0
All addresses:
10.22.115.22 255.255.255.0
IGMP membership:
DHCP: disabled MSS Clamp: disabled
Rx Filter: none Tx Filter: none
IfType: ETHER MAC: 00:90:96:40:c7:a4
Virtual: No Device: //bridge
Routing table:
--------------
Dst: 0. 0. 0. 0 / 0 Gw: 0. 0. 0. 0 If: 1 Cost: 1
Dst: 81.174. 46. *** / 32 Gw: 0. 0. 0. 0 If: 1 Cost: 1
Dst: 10. 22.115. 0 / 24 Gw: 0. 0. 0. 0 If: 2 Cost: 1
Dst: 127. 0. 0. 0 / 8 Gw: 0. 0. 0. 0 If: 16 Cost: 1
Compile time configuration:
---------------------------
QOS support: disabled
Checksum forwarded packets: no
Validate source addresses: no
ATIC Layer 2: not present
IPv6 support: not present
-->
--> port ethernet show
Version = 1.00
RxNoBuffer = 0
RxErrorAlign = 0
MaxMulticastListsize = 64
MaxQueue = 32
PortClassEthernet = true
Reset = false
Disable = false
PromiscuousEnable = true
RxBroadcastEnable = true
RxMulticastEnable = true
RxMulticastAllEnable = true
RxAddressEnable = true
RxPassBad = true
FullDuplexEnable = true
CrcEnable = true
PadShortDataEnable = true
Loopback = false
MAC = 00:90:96:40:C7:A4
HashHigh = 0
HashLow = 0
RxOk = 85963
RxWatchdogTimeouts = 0
RxShortPackets = 0
RxOverlongPackets = 0
RxLateCollisions = 0
Rx8023Frames = 0
RxMIIErrors = 0
RxDribbleNibbles = 0
RxCRCErrors = 0
RxVLAN1Frames = 0
RxVLAN2Frames = 0
RxLengthErrors = 0
RxControlFrames = 0
RxUnsupControlFrames = 0
RxMulticastPackets = 0
RxBroadcastPackets = 4
RxFilterFailures = 0
RxPktFilterPasses = 85968
RxMissedFrames = 0
RxOverruns = 0
RxSyncError = 0
RxSoftSync = 0
RxErrorPackets = 0
TxOk = 89068
TxAborts = 0
TxJabberTimeouts = 0
TxNoCarrier = 0
TxCarrierLoss = 0
TxExcessiveDeferrals = 0
TxLateCollisions = 0
TxExcessiveCollisions = 0
TxUnderrun = 0
TxDeferred = 0
TxLateCollisionRetry = 0
TxCollisions = 0
TxHeartbeatFailures = 0
TxRetriedPackets = 0
MaxFilterEntries = 8
TxErrorPackets = 0
TxAfterOneCollision = 0
TxAfterMoreCollision = 0
--> port ethernet status
MaxQueue = 32
Reset = false
Disable = false
PromiscuousEnable = true
RxBroadcastEnable = true
RxMulticastEnable = true
RxMulticastAllEnable = true
RxAddressEnable = true
RxPassBad = true
FullDuplexEnable = true
CrcEnable = true
PadShortDataEnable = true
Loopback = false
MAC = 00:90:96:40:C7:A4
HashHigh = 0
HashLow = 0
RxOk = 86971
RxBroadcastPackets = 4
RxErrorPackets = 0
TxOk = 90115
TxCollisions = 0
TxErrorPackets = 0
--> security list triggers
Security Triggers:
ID | Name |Type | Port Range |Interval
-------------------------------------------------
-------------------------------------------------
--> security status
Security disabled.
Firewall disabled.
Firewall security level: none.
Firewall session logging enabled.
Firewall blocking logging enabled.
Firewall intrusion logging enabled.
NAT enabled on ppp-0
webserver:Apply Changes
--
bye
miKe
_______________________________________
GNU/Linux - Slackware current - 2.6.24
L.R.U.#219755 L.R.M.#110932 S.R.U.#705
Socio MajaGLUG: www.majaglug.net
Socio AsSoLi: www.softwarelibero.it
More information about the pluto-help
mailing list